Niles-audio HDL-4 Instrukcja Użytkownika Pobierz pdf (Strona 11)

3. Make the connections to the HDL-4. The amplifier/speaker

connectors on the HDL-4 are removable. If you wish, you

may remove the HDL-4's connectors to facilitate installation

see (Figure 3). Strip 3/8" of insulation from the end of each

wire. Tightly twist the end of each wire until there are no

frayed ends. Insert each wire into the appropriate hole on the

spring-loaded connector terminals. Be certain that proper

phasing is observed—connect the positive terminals on the

HDL-4 to the positive terminals on the amplifier and speakers

and the negative terminals on the HDL-4 to the negative ter-

minals on the amplifier and speakers. Re-install the connec-

tors if they were removed. See (Figure 4).

4. Locate the pre-printed Room Labels. Affix the appropriate

label to the recessed area over each ON/OFF selector button.

IGH

EFINITION

PEAKER

ELECTION

YSTEM

Figure3

Removing the Connectors

Figure4

Installing the Connectors

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

Niles-audio HDL-4 Instrukcja Użytkownika Strona 11